![]() (Ensure that the Allow management operating system to share this network adapter is selected.) Click OK to create the switch. Set the name of your new switch and select the network adapter in the pulldown in the External network section. Ensure External is selected and click Create Virtual Switch. In Virtual Switch Manager, go to New virtual network switch. You can access it in the Action pane on the right or by right-clicking the host system’s name and choosing Virtual Switch Manager.Īccess the Virtual Switch Manager in Hyper-V Manager To create a virtual switch using the GUI, run Hyper-V Manager, click the host system, and go to Virtual Switch Manager. (Note: You may need to adjust the NetAdapterName property depending on the name of your local network adapter.) This command creates a new switch named “Virtual Switch” that uses the wired Ethernet adapter and allows the host OS to use the adapter at the same time. ![]() To create a switch using PowerShell, open a PowerShell prompt with Admin rights and run the following command: New-VMSwitch –Name "Virtual Switch" –NetAdapterName "Ethernet" –AllowManagementOS $trueĬreate an external switch in Hyper-V using PowerShell In most cases, you’ll need an external switch that allows the VMs to communicate with the host system, other VMs on the host, other systems on the network, and the Internet (assuming the host system has access to the Internet). Hyper-V will be installed when you reboot.Įnable Hyper-V in Windows 10 with PowerShell Configure a virtual switchįor virtual machines in Hyper-V to access the network, you’ll need to create a virtual switch. To install Hyper-V in Windows 10 with PowerShell, run the following command with Admin rights:Įnable-WindowsOptionalFeature -Online -FeatureName Microsoft-Hyper-V -All Hyper-V Hypervisor not available in Turn Windows features on or off Install Hyper-V with PowerShell Reboot, enable virtualization support, and then try the process again. If the Hyper-V Platform and Hyper-V Hypervisor features are grayed out, virtualization support may not be enabled in the BIOS on your computer. Select the top-level Hyper-V check box and ensure that all the sub-features are selected. Open the Turn Windows features on or off area of the Control Panel and scroll down to Hyper-V. ![]() Turn Windows features on or off in the Cortana search box To install Hyper-V using the GUI, go to the Cortana search box and search for Turn Windows features on or off. The process can vary widely between manufacturers and models, so you may need to consult the support site for your OEM to find the exact process.Įnable Intel Virtualization Technology on a Lenovo ThinkPad On my personal Lenovo ThinkPad, it was in Security, Virtualization, Intel (R) Virtualization Technology. Start the computer, enter the BIOS, and enable the hardware virtualization support. Some OEMs enable it by default, some don’t.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |